MCOM Water Level Indicator equipped with best quality material latest technology. It shows 3 levels of tank (Full, ½, 10%) through high glow LED lights.
The indicator is specifically designed to use where water is taken from any regular source of water like earth water or irregular source like corporation pipeline.
Features: • Programmable Timer • Float Switch Sensors / No Scaling on Sensor ( Carbon Free) We are best in after sale services also and our aim is to provide benchmark services in the industry. Our few beneficial points are mentioned below: • High Quality • Quick Service • Latest Technology • Customer Satisfaction • Specialty: We provide float switch sensors: no scaling/ depositing of any salt [carbon free] on the surface of sensors, even after years. The Concept of Water Level Controller System: • The Water Level Controller System is an Electronic Equipment which when electrically connected to the starter of any given pump set motor will control the operation of the pump set depending upon the water level in the Source and Destination Storage Tank. Advanced Automatic “WATER LEVEL CONTROLLER” unit Manufactured by “MODERN COMMUNICATION TECHNOLOGY “. This system when electrically connected to an Pump set starter, performs the following functions automatically: • Switches ON the Pump set when Water level drops below pre-set level (i.e. T2 level) in Overhead Tank. • Switches OFF the Pump set when Water level in Overhead Tank becomes full (i.e. T1 level). • Switches OFF the Pump set when Water level is low in Sump/Well/Bore well (i.e. S2 level). • Switches ON the Pump set when there is sufficient water in the Sump/ Well / Bore well (i.e. S1 level). • Switches OFF the Pump set when there is a Dry run (i.e. when Water is not being pumped into Overhead Tank due to any reason). • Low Voltage and High Voltage Protection for the Pump set is incorporated. • The system has Surge Voltage/Current Protection for the Pump set. • All these functions are automatically performed.